700ML Jerry Can Blow Molding Machine: A Comparative Guide

TEPAI supply professional and honest service.

Step-By-Step Guide to Using a 700ML Jerry Can Blow Molding Machine

Step 1: Prepare the Machine

- Ensure the machine is clean and free of any debris.- Make sure all the necessary components are in place and functioning properly.- Connect the machine to a power source and turn it on.

Step 2: Prepare the Mold

- Choose the appropriate mold for the 700ML jerry can size.- Inspect the mold for any damages or defects.- Install the mold securely onto the machine.

Step 3: Load the Raw Materials

- Measure and weigh the required amount of plastic resin for the jerry can.- Load the resin into the machine's hopper.- Make sure the resin is evenly distributed and free of any contaminants.

Step 4: Start the Molding Process

- Set the machine to the desired parameters for the jerry can production.- Close the mold and initiate the heating and blowing process.- Monitor the machine for any issues or malfunctions during the molding process.

Step 5: Cooling and Ejection

- Allow the jerry can to cool down inside the mold for the recommended time.- Open the mold and carefully remove the freshly molded jerry can.- Inspect the can for any defects or imperfections.

Step 6: Post-Production Tasks

- Trim any excess material from the jerry can using appropriate tools.- Apply any necessary finishing touches, such as labels or handles.- Store the finished jerry cans in a safe and secure location.By following these step-by-step instructions, you can effectively operate a 700ML jerry can blow molding machine